; G-Code generated by Matthew Upp of GigDigit.com
;
; Invert X,Y, and Z Motor Direction

; This gcode file is intended for the following 3D printers:
; Malyan M300
; Monoprice MP Mini Delta
;
; This file is much longer than it needs to be but is like this to 
; show what is going on.
;
; If when "printing" this file it does not show as completed on the 
; display but the fan pulsed on and off a few times then the invert 
; command was successfully ran and saved. You can turn the printer 
; off and on to make sure the setting was saved.
;
; Lines with only a semicolon are for making line separations only.
; Please add a blank line to the end of the file while editing.
; DokuWiki Code Blocks deletes blank lines at the end of the block but 
; g-code files typically end with a single blank line at the end. 
; (It is not a big deal if you don't add the blank line.)
; 
;
; BEGIN
M107 ; turn fan off in case it was already on
M106 S237 ; turn fan on to signify start
;
;
; The next two lines are the only actual commands that are needed to
; invert the X,Y, and Z motor direction and save.
M562 XYZ ; invert x,y, and z axes
M500 ; save currently loaded settings to eeprom
;
;
; PULSE FAN TO SIGNIFY COMPLETION
M107 ; turn fan off
G4 S1 ; wait 1 second
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
;
M400 ; wait for current moves to finish
M107 ; turn fan off to signify completion
M84 ; disable motors
; END