User Tools

Site Tools


extended_g-code_table

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
extended_g-code_table [2017/10/12 21:28]
Matthew Upp [Table]
extended_g-code_table [2018/04/27 23:04] (current)
Matthew Upp
Line 16: Line 16:
 | M555 P1                                                                 | Reset WiFi interface (reboots WiFi module) ​          | | M555 P1                                                                 | Reset WiFi interface (reboots WiFi module) ​          |
 | M556                                                                    | Display network status ​                              | | M556                                                                    | Display network status ​                              |
-| [[firmware:​motion_controller#​g-code_-_m560|M560]] ​                      | Update firmware using update.bin in microSD card     |+| [[firmware:​motion_controller#​g-code_-_m560|M560]] ​                      | Update firmware using firmware.bin in microSD card     |
 | [[extended_g-code_table#​m561_-_change_thermistor_type|M561]] ​           | Change thermistor type (Hotend and/or Heat bed)      | | [[extended_g-code_table#​m561_-_change_thermistor_type|M561]] ​           | Change thermistor type (Hotend and/or Heat bed)      |
 | [[extended_g-code_table#​m562_-_invert_stepper_motor_direction|M562]] ​   | Invert stepper motor direction ​                      | | [[extended_g-code_table#​m562_-_invert_stepper_motor_direction|M562]] ​   | Invert stepper motor direction ​                      |
extended_g-code_table.txt · Last modified: 2018/04/27 23:04 by Matthew Upp