User Tools

Site Tools


g29

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
g29 [2017/09/30 08:55]
Matthew Upp
g29 [2018/09/20 03:58] (current)
Matthew Upp [Notes]
Line 47: Line 47:
 ==== Notes ==== ==== Notes ====
   * <color #​CC2255>​G29 Z[offset]</​color>​ ; raises   * <color #​CC2255>​G29 Z[offset]</​color>​ ; raises
-  * <color #​CC2255>​G29 Z-[offset]</​color>​ ; lowers+  * <color #​CC2255>​G29 Z-[offset]</​color>​ ; lowers ​if you need to adjust below 0 but it is unlikely to need a negative value
   * Please try a positive offset value first.   * Please try a positive offset value first.
   * Each printer will require fine tuning in regards to the offset value.   * Each printer will require fine tuning in regards to the offset value.
   * Start with a higher value and decrease as necessary to get good first layer adhesion.   * Start with a higher value and decrease as necessary to get good first layer adhesion.
-  * Using negative offset value may send the nozzle digging into the build plate.+  * Using too low or negative offset value may send the nozzle digging into the build plate even if the leveling process appears to have gone well.
  
 ---- ----
g29.1506761707.txt.gz · Last modified: 2017/09/30 08:55 by Matthew Upp