User's Manual
Specifications
Donations & Support
Troubleshooting
Resources and Links
Replacements Parts & Information
Mods & Improvements
How-to
Maintenance
WiFi
Web UI
OctoPrint
Slicer Stuff
Firmware
Downloads
Donations & Support
User Tools
Sidebar
howto:extruder_calibration
Extruder Calibration
Original Steps per mm
| Original Default Values | ||||
| Firmware Version | X | Y | Z | E |
|---|---|---|---|---|
| 41 & below | 56.50 | 56.50 | 56.50 | 48.50 |
| 43 & up | 113.00 | 113.00 | 113.00 | 97.00 |
| If updating to version 43 or higher from 41 or lower, you may need to lower the steps per mm back to the previous values. Motion Controller version 43 is not yet available for download. It may be shipping on new units but testing is needed to make sure it is okay to use with previous released printers. |
||||
Corrected Steps per mm
| Future (corrected) Default Values | ||||
| Firmware Version | X | Y | Z | E |
|---|---|---|---|---|
| 41 & below | 57.14 | 57.14 | 57.14 | 48.50 |
| 43 & up | 114.28 | 114.28 | 114.28 | 97.00 |
| If updating to version 43 or higher from 41 or lower, you may need to lower the steps per mm back to the previous values. Motion Controller version 43 is not yet available for download. It may be shipping on new units but testing is needed to make sure it is okay to use with previous released printers. |
||||
View current values
- Send command “M503” (Sending G-code)
- Must connect via USB. “M503” will not give response via WiFi.
- Look for:
- “Steps per unit:”
- “M92 X56.50 Y56.50 Z56.50 E48.50”
“E48.50” in the example above are the E steps per mm
Calibrating your extruder By: Thomas Sanladerer
https://www.youtube.com/watch?v=YUPfBJz3I6Y
NOTE: When sending commands manually there needs to be a space between the command and the parameters.
For example:
G92E0 needs to be G92 E0
Triffid Hunter's Calibration Guide - E steps
http://reprap.org/wiki/Triffid_Hunter's_Calibration_Guide#E_steps
How to calibrate the Extruder on your 3d Printer
http://www.instructables.com/id/How-to-calibrate-the-Extruder-on-your-3d-Printer/
Calibration - Extrusion
http://reprap.org/wiki/Calibration#Extrusion
How To Calibrate Your Extruder
https://www.matterhackers.com/articles/how-to-calibrate-your-extruder
howto/extruder_calibration.txt · Last modified: 2018/03/10 08:40 by Matthew Upp
Page Tools
Except where otherwise noted, content on this site is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
