User Tools

Site Tools


quick_access_led

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

quick_access_led [2017/08/11 15:49]
Matthew Upp created
quick_access_led [2017/08/12 04:49] (current)
Matthew Upp
Line 1: Line 1:
-====== ​USING THE QUICK ACCESS ​LED BUTTON ​======+====== ​Using The Quick Access ​LED Button ​======
  
 ---- ----
  
 **The Quick Access LED Button (#5 in the User's Manual) is between USB and microSD card slot.** **The Quick Access LED Button (#5 in the User's Manual) is between USB and microSD card slot.**
-  * Pressing the button will automatically start printing the file named auto00.g (formally ​cat.gcode) on the microSD card.  +  * Pressing the button will automatically start printing the file named auto00.g (formerly ​cat.gcode) on the microSD card. The LED will blink green three times then remain illuminated
-  * Pressing the button while printing will pause, pressing again will resume. +  * Pressing the button while printing will pause, pressing again will resume. ​If illuminated,​ the LED will go off when pausing and will be green when resuming. (The pause action may take 5 to 10 seconds to occur) 
-  * Pressing and holding the button for 4 seconds while printing will cancel the job. +  * Pressing and holding the button for 4 seconds while printing will cancel the job. If illuminated,​ the LED will go off when canceling.  
-  * Pressing and holding the button for 4 seconds while in idle state will initialize Wi-Fi smart config for use with the WiFi Connect mobile apps. +  * Pressing and holding the button for 4 seconds while in idle state will initialize Wi-Fi smart config for use with the WiFi Connect mobile apps. The LED will blink blue 3 times then go off but the smart config will still remain active
 +  * When any of one of the three bed switches are activated/​pressed down, the LED will be red.
quick_access_led.txt · Last modified: 2017/08/12 04:49 by Matthew Upp