Follow the steps below to get your Mini Delta connected to your existing 2.4 GHz wireless network.

1. Disconnect USB cable from the printer
2. Plug in the MP Mini Delta.
3. Open the MP 3D Printer WiFi Connect App.
4. Verify the correct SSID is displayed.
5. Enter wireless network password or leave blank if no password is needed.
6. Press and hold the Quick Access LED Button for 4 seconds while in idle state.
7. Release the Quick Access LED button when Smart config started is displayed on screen.
8. Press and hold the middle button.
9. Release the button when the “Smart config started” message is displayed.
10. Tap the “Connect to WiFi” button and within 10-60 seconds the process should complete.
    1. The printer's screen will display “Smart config success” when the process is complete.
    2. The device will display “MP 3D Printer is now connected to Wi-Fi” (message may vary)
    3. You will also notice the Mini Delta has been assigned an IP Address that is displayed at the top of the printer's display.

• This method will work with SSID & passwords that contain multiple spaces, space(s) at the end, special characters, & lower case characters in any location
• This method will work if WiFi password contains a semicolon “;”
• This method will work for configuring open system WiFi networks with no password

• If the correct SSID is not displayed, go to the iPhones Wi-Fi settings and switch to the appropriate wireless network.
• Wi-Fi and USB cannot access the printer simultaneously.
• Disconnect USB cable from the printer if you want to use the Wi-Fi function.
• Wi-Fi works with 2.4 GHz b/g/n networks only.
• If you have a 2.4 GHz and 5 GHz network using the same SSID(wireless network name) you may have trouble connecting the printer to your wireless network.
• For the initial Wi-Fi setup try moving the printer closer to the Wi-Fi router.

1. Perform the same steps to setup Wi-Fi but use an incorrect password
2. The process is complete when:
   1. The printer's screen will display “Smart config success” when the process is complete.
   2. The iPhone will either not show any message and time out or will show a “Mission failed” message after a minute or so.
   3. You will also notice the Delta Mini no longer has an IP Address displayed at the top of the printer's display. It should say no connection.

MP 3D Printer WiFi Connect for iOS - Demo